Polystyrene cutter TOOLCRAFT TC-FC-USB

Polystyrene cutter TOOLCRAFT TC-FC-USB
For simple cutting and modeling of polystyrene (Styropor®). The device can be used in many ways thanks to its easily exchangeable attachments. Ideal for workshops and do-it-yourselfers. Thanks to USB power supply, the device is very flexible and even portable. The power outlet is not necessarily needed, the cutter can be connected to a notebook or power bank for power.
Styrodur® is a registered trademark of BASF SE.

Product parameters:

- Power supply via USB connector
- Incl. 3 quick-change attachments (cutting wire, blade attachment, engraving attachment)
- Swivel joint in handle
- Short heating time
- Swivel joint in the handle: the cutter can therefore always be set to the best working position for optimum results


Technical parameters:

Type: KSF-110
Power: 5 W
Operating voltage: 5 V
External length: 149 mm
Outer width: 30 mm
External height: 30 mm
Outer Ø: 30 mm
Weight: 66 g
Power: USB powered

Properties:
- Approx. 180 ° C (cutting wire), heating time: 60 s
- Approx. 320 ° C (blade attachment), heating time: 60 s
- Approx. 280 ° C (engraving attachment), heating time: 110 s

Scope of supply:
1 basic facility
1x heat cutter
1x engraving attachment
1x cutting attachment
1x stand