Time switch 0-999sec, 0-999min, 0-999h with two times
€7.15
Tax included
5 Items
TP-09830218-EU
El. Bankininkystė, Grynais arba Visa - Mastercard
Nemokamas pristatymas užsakymams nuo 59€.
Suteikiame 14 dienų pinigų grąžinio garantiją
Timer with three adjustable time intervals and two time channels. Both times can be combined differently. Time range 0–999sec, 0–999min, 0–999h, settings apply to both channels simultaneously.
Technical parameters:
- power supply: 12 V
- 6 operating modes - see below
- relay contact 230VAC / 10A or 12VDC / 20A
- dimensions: 48 × 29 mm
- consumption in idle mode: 20 mA
- consumption with closed relay: 120 mA
- panel opening: 45.5 × 26 mm
Operating modes:
- P1–0: the relay closes permanently after time T1 has elapsed
- P1–1: the relay is closed for T1, then it switches off permanently
- P1–2: the relay closes for time T2 after the time T1 has elapsed, then the module is idle
- P1–3: the relay is closed for T1, then it is switched off for T2 and then it closes permanently
- P1–4: the relay switches cyclically to time T2 after time T1 has elapsed - it is switched off at the beginning of the cycle
- P1–5: the relay switches cyclically for time T1 after the time T2 has elapsed - it is switched on at the beginning of the cycle
Time setting:
- P0–0 - setting to seconds mode
- P0–1 - setting to minute mode
- P0–2 -set to clock mode
Settings:
- a short press of the SET button activates the time setting mode:
- T1 - the red display flashes and the time T1 can be set with the arrows
- T2 - the green display flashes and the time T1 can be set with the arrows
- saving of set values is enabled by repeated short press SET or automatically after 6sec of inactivity
- long press of the SET button allows to set time units and operating modes:
-P0 - setting sec (0) - min (1) - hr (2) using the arrows. The settings apply to both channels at the same time
-P1 - setting of operating modes 0–5, see above, also with arrows.
- saving of set values is enabled by repeated short press SET or automatically after 6sec of inactivity
The module does not have a separate Start button. The timing starts by connecting the input voltage
The product is not a stand-alone unit, it requires professional installation.