Marten and rodent repellent KEMO M186 for the car

Ultrasonic marten and rodent repeller with 6 high-voltage surfaces. Quality German product intended for use in cars, agricultural machinery, tractors, connection via vehicle ignition.

The device emits an ultrasound signal with a frequency of 22 kHz. In addition, it contains 6 high-voltage plates, which are charged with a capacitor to 300 volts. These high-voltage plates are installed under the hood in the engine compartment at places near water, air hoses, starter cables and the like. When touching the surface, the animal receives an electric shock, which immediately frightens it. The high voltage plate will automatically recharge.
Extremely low energy consumption (<0.005), when the battery voltage drops below 11.5 V, the device automatically turns off (so that the battery does not discharge during prolonged vehicle downtime).

The device is fixed using self-tapping screws or straps in the engine compartment.

Technical parameters:

- operating voltage: 12 - 15 V / DC (car battery)
- average power consumption: <5 mA
- automatic shutdown: if the battery voltage drops to <11.5 V (± 5%)
- output voltage: approx. 200-300V/DC
- ultrasound frequency: approx. 22 kHz ± 10%
- acoustic pressure: max. approx. 100 dB ± 15%
- ultrasound radiation angle: approx. 150 degrees
- speaker: special ceramic piezo speaker with a spherical aluminum diaphragm
- temperature range: approx. -25 to +80 °C
- functional display: flashing LED (approx. every 5 - 12 s.)
- length of high voltage cable: 1 x approx. 4 m (± 10%)
- fuse in holder: 500 mA
- high voltage surfaces: 6 pcs, 40 x 40 x 1.5 mm - each
- dimensions: approx. 125 x 70 x 31 mm (without cable entry + LED)
- cable for terminal 15: If this cable is connected to "plus", the kun repeller will disconnect. The kun repeller will turn on if it is connected to "minus" or if it has no signal.
- suitable for vehicles with CAN bus
- CE certificate
- homologation: e1